How to use an ATT calling card?

[haile512]

I looked at the menu context and still not quite sure how to do get out going calls to use ATT calling card.  I want to do the following everytime I call an international number:

1.  call 1800callatt
2.  wait for the prompt (~3-5 seconds) then enter 1
3.  wait for the prompt (~2-5 seconds) then enter the calling number.   In my phone book, international numbers are begin with + and then the number, for example +84xxxxxxxx for calling Vietnam.  Att calling needs to push 0184xxxxxxxx#.  I need to change the + to 01 and also enter the # at the end.
4.  Wait for ~2 second, then enter the calling card number and the pin.

Please give me an example on how to do the above.

Thanks,

[admin]

Hi haile 512,

Here is an example:

Rule type: Phone-Outbound
Filter type: Specific Number
Phone #: +*
Action1: Change number
Call to: 1800,,,,,,1,,,,,01{phone}[-1,0]#,,,card number and pin

Maybe you need to add more commas (,) after 1800.
Hope this example works for you.

Regards

[haile512]

Thank you.  This works great.  This software is much better then Sunnysoft Calling Card.

This is great software.  One suggestion, maybe on/off or enable/disable or activate/deactivate feature can be added to the rule menu.  This will allow each rule to be individually be on or off w/o having to open the rule and change action from the current state to normal.  Changing the action does not remove the action(s) that has been entered before, it should be noted.  The added feature will be good to disable a rule right at the rule summary menu.

Thanks once again.  This is a great program and I am strongly recommended to everyone.  I am using it to block calls as well as a calling card program.  I tested with both ATT and Sprint calling cards and prepaid calling card; no problem whatsoever.

Thanks

[admin]

Thank you.

If you are using it on a PocetPC device, you can tap a rule's icon to enable/disable it. (unfortunately this feature does not exist on Smartphone devices).

If you want to disable/enable a rule, just open the configuration window, and uncheck the Enabled checkbox. It is not necessary to change the rule's Action.

Regards.